Searching for elements at certain positions

Procedure

  1. Select “Position” in the Filter Target pop-up menu.

    This allows you to find elements starting at certain positions, either relative to the start of the project or within each bar.

  2. Open the pop-up menu in the Condition column and select the desired condition.
    • If you select any condition other than the Range, Bar Range, Cursor, Loop or Cycle options, you set up a specific position (in PPQ, seconds, samples, or frames) in the Parameter 1 column. Use the Bar Range/Time Base column to specify the time base. Note that the position for Bar Range is measured in ticks related to the start of the bar.

      Figure: Here, the Project Logical Editor will find all elements at the PPQ position 5.1.1. in the project.

    • If you select Inside Range or Outside Range in the Condition column, you set the start position of the range in the Parameter 1 column and the end position in the Parameter 2 column. You can also change the time base using the Bar Range/Time Base column.

      The Project Logical Editor will then find all elements inside or outside this position range.

    • If you select one of the Bar Range options in the Condition column, the Bar Range/Time Base column will show a graphic bar display. You specify the range within the bar by clicking and dragging in the bar display (the specified Bar Range is highlighted).

      Figure: Here, the Project Logical Editor will find elements starting around the second beat in each bar.

      The Project Logical Editor will then find all elements starting inside or outside this Bar Range, in all bars (within the current selection).