Using Pre-Roll and Post-Roll

Prerequisite

On the Transport panel, Lock Punch Points to Locators is activated.

Procedure

  1. Set the locators to where you want to start and end recording.
  2. On the Transport panel, activate Punch In and Punch Out.
  3. Open the Preferences dialog and select Record.
  4. Activate Stop after Automatic Punch Out.
  5. On the Transport panel, activate Pre-roll and Post-roll.
  6. In the Pre-roll Amount and Post-roll Amount fields, enter the pre-roll and post-roll values.
  7. Activate Record.

Result

The project cursor rolls back by the time specified pre-roll value and playback starts. When the cursor reaches the left locator, recording is automatically activated. When the cursor reaches the right locator, recording is deactivated, but playback continues for the specified post-roll value before stopping.