Controller Event Editor

The controller event editor allows you to perform additional scaling operations for selection ranges on existing controller curves.

  • To open the controller event editor, activate the Object Selection tool and drag a selection rectangle on the controller lane.

The controller event editor features the following smart controls for specific editing modes:

  1. Tilt Left

    If you click in the upper left corner of the editor, you can tilt the left part of the curve. This allows you to tilt the event values at the start of the curve upwards or downwards.

  2. Compress Left

    If you Alt-click in the upper left corner of the editor, you can compress the left part of the curve. This allows you to compress or expand the event values at the start of the curve.

  3. Scale Vertically

    If you click in the middle of the upper border of the editor, you can scale the curve vertically. This allows you to raise or lower the event values of the curve in percent.

  4. Move Vertically

    If you click on the upper border of the editor, you can move the entire curve vertically. This allows you to raise or lower the values of the event values of the curve.

  5. Compress Right

    If you Alt-click in the upper right corner of the editor, you can compress or expand the right part of the curve. This allows you to compress or expand the event values at the end of the curve.

  6. Tilt Right

    If you click in the upper right corner of the editor, you can tilt the right part of the curve. This allows you to tilt the event values at the end of the curve upwards or downwards.

  7. Scale Around Relative Center

    If you Alt-click in the middle right corner of the editor, you can scale the curve relative to its center. This allows you to raise or lower the event values horizontally around the center of the editor.

  8. Scale Around Absolute Center

    If you click in the middle right corner of the editor, you can scale the curve absolute to its center. This allows you to raise or lower the event values horizontally around the center of the editor.

  9. Stretch

    If you click on the lower border of the editor, you can stretch the curve horizontally. This allows you to move the event values of the curve to the left or to the right.