Creating New Files From Events

An audio event plays a section of an audio clip, which in turn refers to one or more audio files on the hard disk. However, you can create a new file that consists only of the section that is played by the event.

Procedure

  1. Select one or several audio events.
  2. Set up fade in, fade out, and event volume.

    These settings will be applied to the new file.

  3. Select Audio > Bounce Selection.

    You are asked whether you want to replace the selected event or not.

  4. Do one of the following:
    • To create a new file that only contains the audio in the original event, click Replace.

    • To create a new file and add a clip for the new file to the Pool, click No.

Result

If you clicked Replace, a clip for the new file is added to the Pool, and the original event is replaced by a new event playing the new clip.

If you clicked No, the original event is not replaced.

Note

You can also apply the Bounce Selection function to audio parts. In that case, the audio from all events in the part is combined to a single audio file. If you select Replace when asked, the part is replaced with a single audio event playing a clip of the new file.