Chorus

This plug-in is a single-stage chorus effect. It works by doubling the audio that is sent into it with a slightly detuned version.


 

Cubase LE

Cubase AI

Cubase Elements

Cubase Artist

Cubase Pro

Nuendo

NEK

Included with

X

X

X

X

X

X

Side-chain support

X

X

X




Rate

If tempo sync is deactivated, this sets the sweep rate.

Sync

Activates/Deactivates tempo sync.

Width

Sets the depth of the chorus effect. Higher settings produce a more pronounced effect.

Spatial

Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.

Waveform Shape selector

Allows you to select the modulation waveform, altering the character of the chorus sweep. A sine and a triangle waveform are available.

Delay

Affects the frequency range of the modulation sweep by adjusting the initial delay time.

Filter Lo/Hi

Allow you to roll off low and high frequencies of the effect signal.

Note

If side-chaining is supported, the modulation can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the modulation is controlled by the side-chain signal’s envelope. For a description of how to set up side-chain routing, see the Operation Manual.