Adding Flams
Procedure
- Click in the lower left corner of the step you want to add a flam to.
Little squares appear in the step when you point the mouse at it. If you click a step, the first square is filled to indicate that you added a flam.
- Click again to add the second and third flam.
- In the lower left section of the Beat Designer panel, make settings for the flams that you created.
To add the flams before or after the drum step, drag a position slider to the left or right.
If you add flams before the first drum step in a pattern, this is indicated in the display by a small arrow in the top left corner of this step. Starting playback at the normal pattern start would result in these flams not being played.
To set the velocity for the flams, use the vertical sliders to the right of the flam sliders.
- Start playback to hear the flams you created.