StereoDelay
StereoDelay has two independent delay lines which either use tempo-based or freely specified delay time settings.
Cubase LE |
Cubase AI |
Cubase Elements |
Cubase Artist |
Cubase Pro |
Nuendo |
|
---|---|---|---|---|---|---|
Included with |
– |
– |
– |
X |
X |
X |
Side-chain support |
– |
– |
– |
X |
X |
X |
This plug-in works only on stereo tracks.
- Feedback
-
Set the number of repeats for each delay.
- Delay
If tempo sync is activated, this sets the base note value for the delay. If tempo sync is deactivated, the delay time can be set freely in milliseconds.
- Sync
Activates/Deactivates tempo sync for the corresponding delay.
- Mix
Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.
- Lo Filter
Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.
- Pan
-
Sets the stereo position.
- Hi Filter
Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.
If side-chaining is supported, the delay can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the delay repeats are silenced. If the signal drops below the threshold, the delay repeats reappear. For a description of how to set up side-chain routing, see the “Operation Manual”.