StereoDelay

StereoDelay has two independent delay lines which either use tempo-based or freely specified delay time settings.


 

Cubase LE

Cubase AI

Cubase Elements

Cubase Artist

Cubase Pro

Nuendo

Included with

X

X

X

Side-chain support

X

X

X


Note

This plug-in works only on stereo tracks.



Delay

If tempo sync is activated, this sets the base note value for the delay. If tempo sync is deactivated, the delay time can be set freely in milliseconds.

Sync

Activates/Deactivates tempo sync for the corresponding delay.

Feedback

Set the number of repeats for each delay.

Filter Lo

Affects the feedback loop of the effect signal and allows you to roll off low frequencies. The button below the knob activates/deactivates the filter.

Filter Hi

Affects the feedback loop of the effect signal and allows you to roll off high frequencies. The button below the knob activates/deactivates the filter.

Pan

Set the stereo position for each delay.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value as you can control the dry/effect balance with the send.

Note

If side-chaining is supported, the delay can also be controlled from another signal source via the side-chain input. If the side-chain signal exceeds the threshold, the delay repeats are silenced. If the signal drops below the threshold, the delay repeats reappear. For a description of how to set up side-chain routing, see the Operation Manual.