Automation Event Editor

The automation event editor allows you to edit selected events on the automation track. The automation event editor is only available for automation ramp curves.

Note

All editing in the automation event editor only affects the automation events that are part of the selection.

To open the automation event editor, do one of the following:

  • Activate the Object Selection tool and drag a selection rectangle on a ramp type automation track.

  • Activate the Range Selection tool and select a range on a ramp type automation track.

    Note

    If you work with the Range Selection tool, the smart control for Stretch is not available.

The automation event editor features the following smart controls for specific editing modes:

  1. Tilt Left

    If you click in the upper left corner of the editor, you can tilt the left part of the curve. This allows you to tilt the event values at the start of the curve upwards or downwards.

  2. Compress Left

    If you Alt-click in the upper left corner of the editor, you can compress or expand the left part of the curve. This allows you to compress or expand the event values at the start of the curve.

  3. Scale Vertically

    If you click in the middle of the upper border of the editor, you can scale the curve vertically. This allows you to raise or lower the event values of the curve in percent.

  4. Move Vertically

    If you click on the upper border of the editor, you can move the entire curve vertically. This allows you to raise or lower the values of the event values of the curve.

  5. Compress Right

    If you Alt-click in the upper right corner of the editor, you can compress or expand the right part of the curve. This allows you to compress or expand the event values at the end of the curve.

  6. Tilt Right

    If you click in the upper right corner of the editor, you can tilt the right part of the curve. This allows you to tilt the event values at the end of the curve upwards or downwards.

  7. Scale Around Relative Center

    If you Alt-click in the middle right border of the editor, you can scale the curve relative to its center. This allows you to raise or lower the event values horizontally around the center of the editor.

  8. Scale Around Absolute Center

    If you click in the middle right corner of the editor, you can scale the curve absolute to its center. This allows you to raise or lower the event values horizontally around the center of the editor.

  9. Stretch

    If you click on the lower border of the editor, you can stretch the curve horizontally. This allows you to move the event values of the curve to the left or to the right.

Note

To edit the automation curves on several tracks simultaneously, select the automation events using the Object Selection tool or the Range Selection tool on the corresponding automation tracks, and hold down Ctrl/Cmd while using the smart controls.

Note

If you select automation events using the Range Selection tool, additional automation events are automatically created at the start and the end of the selection. This ensures that the entire selection is edited.