Flanger

This is a classic flanger effect with added stereo enhancement.

Delay

Affects the frequency range of the modulation sweep by adjusting the initial delay time.

Feedback

Determines the character of the flanger effect. Higher settings produce a more metallic-sounding sweep.

Mode

Allows you to toggle between LFO and Manual mode.

In LFO mode, you can define the sweep rate or sync it to the project tempo. In Manual mode, you can change the sweep manually.

Rate

If Tempo Sync is activated, Rate allows you to specify the base note value for synchronizing the flanger sweep to the tempo of the host application (1/1 to 1/32, straight, triplet, or dotted).

If Tempo Sync is deactivated, the sweep rate can be set freely with the Rate dial.

Sync

Activates/Deactivates tempo sync.

Spatial

Sets the stereo width of the effect. Turn clockwise for a wider stereo effect.

Mix

Sets the level balance between the dry signal and the wet signal. If the effect is used as a send effect, set this parameter to the maximum value, as you can control the dry/effect balance with the send level.

Lo Range/Hi Range

Set the frequency boundaries for the flanger sweep.

Waveform Shape

Allows you to select the modulation waveform, altering the character of the flanger sweep. A sine and a triangle waveform are available.

Lo Filter/Hi Filter

Allow you to roll off low and high frequencies of the effect signal.